Henry 2K 1300 Watt Linear Amplifier with EIMAC 3500Z For Sale -
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Henry 2K 1300 Watt Linear Amplifier with EIMAC 3500Z:
$900.00
Please read this carefully...this is for local pick up only and only to licensed Ham Operators. On pick up you will have to show me your current and valid FCC Ham Operator license.
I just upgraded to a newer amp and I am selling this used but working amplifier....Serial Number 356...the EIMAC Tubes are Brand New.
TYPE AND FUNCTIONOF EQUIPMENT
A floor console 2000 watt PEP input (1200wattPEP nominal output) RF linear amplifier covering the 3.5 to 30.0 MHz frequencyrange.
TYPE OF EMISSION
SSB/AM/CW or RTTY(class AB high x15.0" wide x 16.5" deep. -Approximately 125 pounds.
DUTY CYCLE
Continuous at ratedoutput.
POWER REQUIREMENTS
115 VAC at 30 amps or 230 VAC at 15 amps, 50 or 60 Hz.
ALC CIRCUIT
Prevents overdrivefrom high power exciters and boosts the average talk power of your signal.
COOLING
Forced air cooled.
PLATE POWER INPUT
1000 watts with speech. Distortion products are at least 35 dBdown from the signal.
FREQUENCY RANGE
80 Meters - 3.5 to 4.0 MHz
40 Meters - 7.0 to 7.5 MHz
20 Meters,- 14.0 to 14.5 MHz
15 Meters - 21.0 to 21.5 MHz
10 Meters - 28.0 to 30.0 MHz'
All amplifiers will work on all WARC bands and most frequenciesbetween 3.5 and 30.0 MHz.
INPUT IMPEDANCE
50 ohms nominal withtuned input circuits.
OUTPUT IMPEDANCE
50 ohms unbalanced "SWR < 2:1).
TUBE COMPLEMENT
Two Eimac 3-500 Zglass envelope triodes.
HARMONIC ANDSPURIOUS RADIATION
2nd Harmonic - better than 50 dB down.
3rd Order Distortion - better than -35 dB at full output.
NOISE LEVEL
40 dB or better below 1-tone carrier at 1000 watts output.
PLATE VOLTAGE
SSB 3000 to 3200 VDC.
CW 2000 to 2200 VDC.
CABINETRY
All aluminum cabinets, double shielded in RF sections.
ANTENNA RELAYSYSTEM
Built-in 12 VDC antenna relays automatically transfer the exciterto the antenna when the power switch is in the standby or off position.Built-in DC power supply to offer hum-free relay operation.
METERING
Plate current, plate voltage, grid current are metered.
PROTECTION DEVICES
All circuits are protected by fuses, circuit breakers or cabinetinterlocks.